Welcome to TINA2 3D Printer Wiki
Welcome to TINA2 3D Printer Wiki
Step1: Turn on your F192 printer, connect the printer to your computer with the USB cable from accessory box.
Step2: Double click the below firmware updater, see below photo:
Step3:
Use a screwdriver or some tools to press the reset button which on the right side of the printer, and DO NOT RELEASE.
Step4:
Click the “update” button AND release the reset button IMMEDIATELY. Now you will see uploading, see below photo.
Wait until the upload is completed:
Step5:
After all this done, go back to the screen and click the “restore factory”, then shut down your printer. After a few seconds, restart your printer. Now resetting process is finished!