Welcome to TINA2 3D Printer Wiki
Sidebar
upgrade_wifi_firmware:tina2
Table of Contents
Update Wi-Fi firmware
1.Under the situition of TINA2 connected to network, go to Control Panel → Network Settings → Wifi Device OTA
2. If there is no new WIFI firmware, the screen prompts No new firmware found.
3. If there is new WIFI firmware, Begin ota updating... will be prompted on the screen.
Wait 1 minute, after the firmware upgrade is complete, the screen will prompt OTA update completed. If the screen prompts Firmware Upgrades Failed or more than 3 minutes, the upgrade does not end, please turn off the printer power, wait 10 seconds, then try again.
upgrade_wifi_firmware/tina2.txt · Last modified: 2020/09/21 07:30 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
